Showing : 104 SIME PLANET SUPER 4 W.M 600MM Parts.
3 WAY CONNECTOR FOR VENTURI PIPES TO AIR PRESSURE SWITCH
ANODE MAGNESIUM Ø 22 L=400
AUTOMATIC AIR VENT 3/8 INCH
BALL COCK 1/2 x 15 COLD WATER INLET
BALL COCK 3/4 x 22 FLOW / RETURN VALVE
BRACKET EXPANSION VESSEL FIXING
BRACKET EXPANSION VESSEL LOWER FIXING
CABLE CONNECTOR 4 POLE STOCKO
CABLE CONNECTOR 6 POLE LUMBERG
CABLE CONNECTOR 6 POLE STOCKO
CABLE CONNECTOR 7 POLE LUMBERG
CABLE CONNECTOR 8 POLE STELVIO
CABLE CONNECTOR PUMP L=650
CAP FOR 3-WAY JUNCTION ON VENTURI PIPES FROM FAN
CASING FRONT PANEL OUTER CASE
CASING FRONT PANEL RIGHT HAND EXTENSION OUTER CASE
CASING LEFT HAND SIDE PANEL OUTER CASE
COMBUSTION CHAMBER FRONT PANEL INNER CASE
COMBUSTION CHAMBER SIDES & REAR COMPLETE INNER CASE
CONTROL PANEL FRONT OF CONTROL CASE ONLY
CONTROL PANEL REAR COVER FOR CONTROL BOX
CONTROL PANEL ROOM STAT CONNECTION COVER TO REAR OF CONTROL BOX
CONVERSION KIT LPG TO NAT GAS 25-30 kW
CONVERSION KIT NAT GAS TO LPG
D.H.W. TANK SANITARY 2.5 LITRE EXPANSION VESSEL
ELBOW 1/2 x 15mm HOT WATER OUTLET
ELECTRODE IGNITION WITH 450mm LEAD
EXPANSION VESSEL 8 LITRE RECTANGULAR 3/8 in M
FASTENER FOR SELF TAPPING SCREW OUTER CASING CLIP
FLANGE D.H.W. CYLINDER Ø 138
GASKET 12.5MM X 18.5MM X 3MM
GASKET RUBBER Ø 130 D.H.W. CYLINDER FLANGE TO CYLINDER
INJECTOR MAIN BURNER NP 130 NAT GAS M6
INSULATION FRONT COMBUSTION CHAMBER
INSULATION REAR COMBUSTION CHAMBER
INSULATION SIDE COMBUSTION CHAMBER
NEON 12 WAYS OUT ON FACIA
O-RING 3068 FLOW / RETURN PIPES
PCB MAIN BOARD WITH IGNITION
PIPE CONNECTS D.H.W. HEAT EX TO EXPANSION VESSEL
PIPE CONNECTS D.H.W. STORAGE TANK TO SANITARY TANK
PIPE CONNECTS PUMP TO HEAT EX WITH TAPPING FOR WATER PRESSURE SWITCH
PIPE CONNECTS TANK TO SAFETY VALVE WITH TAPPING FOR FILLING LOOP
PIPE FLEXIBLE FILLING LOOP
PIPE FLEXIBLE FILLING LOOP 3/8
PIPE FLOW CONNECTS D.H.W. TANK TO FLOW PIPE
PIPE HEAT EX INLET FROM PUMP
PIPE RETURN D.H.W. CYLINDER
PRESSURE RELIEF VALVE 1/2 3 BAR
PRESSURE RELIEF VALVE 1/2 7 BAR
SCREW SELF TAPPING T.C.B. 8SPx3/4
SEAL OUTER FLUE RUBBER RING TOP OF SEALED CHAMBER Ø 81
SEALED CHAMBER FRONT PANEL INNER CASE
SEALED CHAMBER LEFT HAND SIDE PANEL INNER CASE
SEALED CHAMBER RIGHT HAND SIDE PANEL INNER CASE
SENSOR TEMPERATURE L=1120
SMOKE CHAMBER HEAT EX TOP COVER INNER CASE
SPINDLE SELECTOR ( PCB TO CONTROL KNOB )
SPRING CLIP HEAT EXCHANGER TO PIPES
THERMISTOR ( WET POCKET )
THERMOSTAT LIMIT STAT 80°C
THERMOSTAT OVERHEAT 100°C SAFETY STAT
THERMOSTAT PHILE HOLDER 1/2 Ø 7,5x8,5x600
TRIMMER SPINDLE POTENTIOMETER Ø 5
TRIMMER SPINDLE POTENTIOMETER Ø 6
VALVE NON RETURN ON FILLING LOOP
WASHER COPPER Ø 6 FOR BURNER INJECTOR
WASHER GASKET Ø 10,2x14,8x2 3/8 AAV
WASHER GASKET Ø 17x24x2 3/4
WASHER GASKET Ø 22x30x2 1
WASHER GASKET Ø 5,5x11x2 1/4